HIDA Scan
A HIDA (hepatobiliary iminodiacetic acid ) scan is an imaging test. It can be used to check for problems in the liver, gallbladder, and the tubes inside and outside the liver (bile ducts). During the test, a small amount of radioactive substance (tracer) is injected into a vein in your arm or hand. Pictures are then taken to track the movement of the tracer. The test takes about 2 hours. In some cases, more pictures may need to be taken after a wait of 4 hours. You’ll be told as the test progresses how long your test may take.
Before the test
-
Follow any directions you’re given for not eating or drinking before the procedure. Your healthcare provider will give you instructions if required.
-
Tell your healthcare provider what medicines you’re taking. This includes vitamins, herbs, and over-the-counter medicines. You may be told to stop taking some or all of them in the days before the test.
-
Follow any other instructions you’re given to get ready for the test.
What to tell the technologist
Let the technologist know if you:
-
Are taking any medicines or have allergies to any medicines. Some medicines may prevent accurate test results.
-
Had recent X-rays or tests that used barium
-
Had recent surgery or illness
-
Have other health problems, such as diabetes
-
Are pregnant or think you might be pregnant
-
Are breastfeeding
- Smoke or use other tobacco products
During the test
The test is done by a nuclear medicine or radiology technologist. It can be done in a hospital or test center:
-
You’ll lie on your back on a table. A special camera (also called a scanner) will be positioned above your belly (abdomen).
-
An IV (intravenous) needle or IV line is placed into a vein in your arm or hand. The tracer is then injected through the IV line.
-
Pictures are taken as the tracer follows the movement of bile through the liver, gallbladder, and bile ducts, and the first part of the small intestine (duodenum). Bile is a substance made by the liver that helps you digest fat.
-
You’ll need to lie still to help ensure that the pictures are not blurry.
-
Based on your healthcare provider's practices, you may be given a substance by mouth or injected through a vein that causes the gallbladder to contract and release bile. Be sure to let the technologist know if you feel discomfort. This could indicate gallbladder dysfunction.
-
If needed, more pictures may be taken after 4 hours.
After the test
-
The technologist will let you know when the test is completed.
-
The tracer will pass out of the body in your stool and urine within 24 hours. Drink plenty of fluids to help the tracer pass.
Follow-up
Your healthcare provider will go over test results with you when they are ready. This is likely within a few days of the test.
Possible risks
Possible risks of this imaging test can include:
-
Problems at the IV site
-
Allergic reaction to the tracer or medicine used during the test
-
Radiation exposure from the tracer